Consumer Student - Pontoons Companies

Consumer Student - Pontoons Companies

Blog Article

How is the plumbing in your home working? If you have dripping taps or slow moving drains it may be time to get your plumbing and plumber to work together.

If none of these materials is available to you you can always elect toilet to soak rags or towels in hot water and wrap them around the frozen pipe. This will probably take longer than any of the methods previously mentioned.

With a putty knife, carefully scrape the remaining parts of the wax ring from the area. Clean the spot so that the new wax ring will be level. Place a new wax ring on the opening and replace the toilet. Bolt it back onto the floor, reconnect the water line repair supply tube and watch for leaks as the water is turned back on.

One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.

Depending on your repair job you might need a bucket that will fit below the sink trap, as well as some rags and newspaper. Masking tape is useful for labeling and for wrapping around the heads of the wrench to protect your chrome tap handles. Rubber gloves are recommended, particularly when working with the toilet, but there are greases and glues that you may not want on your hands.

Here are some general cautions. Do not begin jobs on holidays, weekends, or at times when plumbers raise their rates or are difficult to reach. Do start early leaving plenty of daylight to call a plumber if something goes wrong. Study the situation carefully. Think about what might happen if something suddenly broke and what the effects would be. Old corroded copper tubing might break in the wall when you are wrenching an angle stop that supplies the water line repair to your toilet. A flood in the wall could be costly. If the angle stop, on the other hand, is new and shuts off easily and you have another toilet in the house then it might make sense to repair the toilet yourself. Be honest, too. Are you handy with tools? Did you do well in shop classes in school?

For a newly installed icemaker, you will need up to 24 hours to let the machine function and cool down. A newly installed icemaker may not work until the ice mold temperature has dropped to about 15F - 16F degrees. If you have just added a water line to the refrigerator, it may take up to about an hour and a half for the machine to start working. Also, a newly installed water line may have air in the line. It can sometimes take a few ice making cycles to clear the line of air.

Over the counter drain cleaning products offer convenience and effective results. However, they are best left to those who need to simply improve the flow of water, not those who need to repair it.

Report this page